HAMAC 8CBM MIXING DRUM TO GUATEMALA
HAMAC HN938 backhoe loader was delivered successfully to PERU
Failure analysis and troubleshooting for Wire Cage Welding Machine
Source: Hamac Machinery
Wire cage welding machine used in the production of steel cage, put the tube in the cement machinery mould system for the production of a reinforced concrete pipe, but in actual use may appear may appear unstable failure of welded steel, the following is the analysis of cause of trouble and remedy method.
Fault:
1, steel surface oil and corrosion.
2,. Welding wheel too groove
3 deep groove welding wheel, welding wheel or conductive wheel pressure is too small
4, conductive block or conductive wheel wear.
5 welding of two primary side of the transformer connected copper foil, poor contact steel, the contact surface oxidation or the fastening screw loosening.
6 conductive copper sleeve groove deep, loose slot, dirty.
7, welding voltage is too low. Method: to replace steel or pickling processing; car repair; adjustment; replacement or repair; clean and tighten; replacement tank; adjust the voltage.
Fault:
1, steel surface oil and corrosion.
2,. Welding wheel too groove
3 deep groove welding wheel, welding wheel or conductive wheel pressure is too small
4, conductive block or conductive wheel wear.
5 welding of two primary side of the transformer connected copper foil, poor contact steel, the contact surface oxidation or the fastening screw loosening.
6 conductive copper sleeve groove deep, loose slot, dirty.
7, welding voltage is too low. Method: to replace steel or pickling processing; car repair; adjustment; replacement or repair; clean and tighten; replacement tank; adjust the voltage.
There is no lowest price, only lower price. You get what you pay for. We hope you are looking for the perfect working performance of the equipment, not the low-priced inferior goods. HAMAC only provide our clients with high quality machines. Wish a cooperation with you in the future.
